SigenStor/Sigen PV Max
Connectivity
Click the "Connectivity" area to view the communication method of the device connecting to the network.
1
Ethernet
Displays the connection status of Fast Ethernet.
For Fast Ethernet, network parameters are automatically obtained using a DHCP server. To edit parameters, do the following:
Configure a WLAN that can be normally connected to the Internet, or insert Sigen CommMod.
Wait until "WLAN" or "Cellular" is displayed as "Connected,” and disconnect the network cable.
Set "Obtain IP address automatically" to
and edit parameters.Re-connect the network cable to the device.
2
WLAN
Displays the connection status of WLAN. If the connection status is displayed as "Not connected,” but you want to use the WLAN to connect to the Internet, do the following:
In parallel mode, identify the connection status of WLAN in "System Settings.” If the status is displayed as "Connected,” the device is communicated over WLAN, and no more action is required. If the status is displayed as "Not connected,” configure the WLAN as described in 2.3.1.5 Grid scheduling.
In non-parallel mode, configure the WLAN as described in 2.3.1.5 Grid scheduling.
3
Cellular
Displays the connection status of 4G network. If the connection status is displayed as "Not connected" and you want to use the 4G network to access Internet, do the following:
In parallel mode, identify the connection status of 4G network in "System Settings.” If the status is displayed as "Connected,” the device is communicated over the 4G network, and no more action is required. If the status is displayed as "Not connected,” please make sure that Sigen CommMod is inserted.
In non-parallel mode, please make sure that Sigen CommMod is inserted.
When 4G is used for communication, users can view the monthly traffic usage and set a traffic usage threshold for each month.
History maintenance
By clicking "Maintenance,” you can clear historical data.
When you click "Reset,” the device restarts.
When you click "Erase All Content,” performance data within 5 minutes, alarms, and hourly/daily/monthly/yearly generating capacity, operation logs, device information will be cleared. Please exercise caution with this action.
Power on/off
By clicking "Maintenance" and then "Power-off" or "Power-on,” you can power the system on or off.
Last updated
Was this helpful?