Local Access

Settings

Scan the SN code label on the accompanying materials. If it is lost, scan the SN code on the side of the inverter.

No.	Parameter name	Description
1	Log Download	After connecting to the device locally, download its operation logs.
2	Software Update	Click to upgrade the locally connected device's software.
3	self-diagnosis	Tap "Diagnostics for Locally Connected Device".
4	Connectivity	Ethernet, WLAN, Cellular Network Configuration
5	Maintenance	Device Power On/Off

Connectivity

No.	Parameter name	Description
1	Ethernet	Display FE connection status. Ethernet: After configuring this parameter, it takes effect for Ethernet, WLAN, and Cellular. Primary DNS: Primary DNS server for domain name resolution (non-editable). Secondary DNS: Secondary DNS server for domain name resolution (editable). Obtain IP address automatically: When set to "", IP addresses are obtained automatically. When set to "", users need to configure a static IP address. IP Address: FE IP address of the current SigenStor/SigenStack Unit. Gateway: FE gateway of the current SigenStor/SigenStack Unit. Subnet Mask: FE subnet mask of the currentSigenStor/SigenStack Unit. FE network connection parameters are set to DHCP by default. If you need to modify them, follow these steps: Set "Obtain IP address automatically" to "", then modify the parameters. Re-plug the network cable used for connectivity into the device.
2	WLAN	Display WLAN connection status. If it shows "Not Connected" here, but you intend to use WLAN for network connectivity, please follow the instructions below: Before configuring WLAN communication, ensure that the antenna is installed on the device. Connecting to an unencrypted WLAN may result in network unavailability and is not recommended. When the device can only use WLAN for network connectivity, do not switch to other wireless router WLANs. Tap "Go Set Up" to configure the WLAN network.
3	Cellular	Display 4G connection status. If it shows "Not Connected" here, but you intend to use 4G for network connectivity, please follow the instructions below: Before configuring 4G communication, ensure that the Sigen CommMod is inserted. When using 4G communication, you can view the current monthly data usage.

(Optional) Off-grid Self-powered Setting

• This feature is only available in C&I power stations.

• After the off-grid self-powered feature is enabled, the device can operate off-grid to supply power to construction equipment.

No.	Parameter name	Description
1	Off-grid self-powered device	When it is set to , the off-grid self-powered feature is enabled.
2	Output Mode	Single Phase: In this mode, the inverter draws power from phases L1 and L2 of the three-phase grid to supply power to single-phase loads. Three-Phase Three-Wire: In this mode, the inverter draws power from phases L1, L2, and L3 of the three-phase grid to supply power to three-phase loads (Sigen PV (50–110)M1-HYB series is the load port).
3	Serial number of the connected device	Enter the SN of the self-powered device.