Remote Connectivity of the Device

No.	Parameter name	Description
1	Ethernet	Display FE connection status. Ethernet: After configuring this parameter, it takes effect for Ethernet, WLAN, and Cellular. Primary DNS: Primary DNS server for domain name resolution (non-editable). Secondary DNS: Secondary DNS server for domain name resolution (editable). Obtain IP address automatically: When set to , IP addresses are obtained automatically. When set to , users need to configure a static IP address. IP Address: FE IP address of the current SigenStor/SigenStack Unit. Gateway: FE gateway of the current SigenStor/SigenStack Unit. Subnet Mask: FE subnet mask of the currentSigenStor/SigenStack Unit. FE network connection parameters are set to DHCP by default. If you need to modify them, follow these steps: Configure a functional WLAN for internet access, or insert the Sigen CommMod. After "WLAN" or "Cellular" shows "Connected", unplug the network cable used for connectivity from the device. Set "Obtain IP address automatically" to , then modify the parameters. Re-plug the network cable used for connectivity into the device.
2	WLAN	Display WLAN connection status. If it shows "Not Connected" here, but you intend to use WLAN for network connectivity, please follow the instructions below: Before configuring WLAN communication, ensure that the antenna is installed on the device. Connecting to an unencrypted WLAN may result in network unavailability and is not recommended. When the device can only use WLAN for network connectivity, do not switch to other wireless router WLANs. Tap "Go Set Up" to configure the WLAN network.
3	Cellular	Display 4G connection status. If it shows "Not Connected" here, but you intend to use 4G for network connectivity, please follow the instructions below: Before configuring 4G communication, ensure that the Sigen CommMod is inserted. When using 4G communication, you can view the current monthly data usage.